錆び付いた時計も可能な限り修復します。

We will restore rusty clocks as much as possible.

This was a customer-supplied repair request we received the other day.

The rust was quite severe this time, so we performed an overhaul and replaced all necessary parts.

 

 

This is the Portofino, which gained popularity with IWC in the 1990s.

Its simple design remains highly popular even today.

 

When we first examined the watch, the inside of the crystal was covered with rusted iron dust,

and to be honest, we weren't sure if it could be repaired.

 

We managed to remove the movement first,

but not only the crystal, but also the dial was covered with iron dust.

We carefully removed the rust to avoid damaging the printing.

 

After cleaning the case in a cleaning machine to remove dirt and rust,

it looked much cleaner, raising our expectations for the repair.

 

We then handed it over to our watchmaker, who confirmed that it could be repaired.

However, the crown's gasket was stuck and the winding stem was severely rusted, so they needed to be replaced,

and damage was also found on the stem, so we arranged for replacement parts.

 

It took about two months to source the parts, which delayed the turnaround time,

but the repair was successfully completed and delivered to the customer.

 

This time:

Overhaul: ¥33,000

Crown replacement: ¥15,400

Winding stem replacement: ¥8,800

Stem replacement: ¥19,800

Total: ¥77,000

 

For watches with visible, major damage,

requesting a repair from the manufacturer can result in an unimaginably high repair cost,

and other shops may refuse to repair them.

 

However, if you look closely at the condition of the watch, you may find that the damage was caused by a surprisingly simple issue,

and that it might be possible to repair it.

 

Please contact us for a consultation first.

It might be possible to repair it for far less than the cost of buying a new watch!